熱水鍋爐軟化水設備一般采用陽離子交換樹脂，去除水中的Ca2+、Mg2+。我們在對熱水鍋爐進行軟化處理時，當樹脂長時間吸收鈣鎂離子之后，需要再生。在安裝熱水鍋爐軟化水設備時，應該注意以下細節問題，來確保設備正常運作。
Hot water boiler water softening equipment commonly used cation exchange resin to remove water, Ca2 +, Mg2 +. We softened hot water boiler, when the resin after prolonged absorption of calcium and magnesium ions in need of regeneration. When installing hot water boiler water softening equipment, you should note the following details, to ensure proper operation.
①排污管不裝閥門，長度應不大于6米，出口需低于閥體，避免虹吸現象。
① outfall valve is not installed, the length should not exceed six meters, export demand is lower than the body, to avoid siphoning.
?、诂F場除了有鍋爐軟化水設備外，還應具備一個220伏特電源。
② the scene in addition to the boiler water softening equipment, should also have a 220 volt power supply.
③進水口水壓應該大于0點15兆帕，如低于此值，需要采取相應措施。
③ saliva water pressure should be greater than 0:15 MPa, as below this value, the need to take appropriate measures.
?、軕獙艿捞砑邮芰χ?，避免控制閥受力。
④ add force to deal with the pipe support, control valve to avoid stress.
?、轃崴仩t軟化水設備進水管接入自來水管時，需要安裝倒流防止器。
When hot water boiler water softening equipment ⑤ inlet water pipe access, you need to install backflow prevention device.
